Tag Archives: IoT

Raspberry Pi 3 in a tin case

I recently got a Raspberry-Pi 3 Model B as a development platform for Internet-Of-Things projects. The very first task was to give it an adequate housing, so I decided to put it into an Altoids tin.

raspi Altoids-tin

 

 

 

 

 

tools used:

  • sticky-tape
  • permanent marker
  • opinel no8 carbon steel knife
  • sandpaper

I transfered the  shapes and locations of the Pi´s plugs onto the sticky tape via the marker.
The tape was put on the Aldoids tin afterwards and the shape was cut out with the Opinel  knife. Although the Opinel did the job quite well maybe I should just use a dremel next time.

Raspi-logo

raspi-sandingWell, actually it turned out the PCB was a bit too large to fit in the Altoids so I sanded down the edges of the PCB almost up to the screwholes. Of cause you have to pay attention not to destroy any circuits or components.

To isolate the board from the metal case to prevent shortening components I put a plastic card at the bottom of the tin.